Select Git revision
Search by author
- Any Author
- authors
-
Abhiram Balasubramanian abhiram
-
Anton Burtsev
aburtsev
-
Charlie Jacobsen cjacobsen
-
David Detweiler ddetweiler
-
David Johnson johnsond
-
Michael Quigley MichaelQuigley
-
Mike Hibler hibler
-
Robert Ricci ricci
-
Sarah Spall spall
-
Scotty Bauer ScottyB
-
Vikram Narayanan vikram
- Nov 29, 2009
-
-
PJ Waskiewicz authored
This patch extends the ethtool interface to display what PHY is currently connected to a NIC. The results can be viewed in ethtool ethX output. Signed-off-by:
Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com> Signed-off-by:
Jeff Kirsher <jeffrey.t.kirsher@intel.com> Signed-off-by:
David S. Miller <davem@davemloft.net>
-
PJ Waskiewicz authored
This patch allows a base driver to specify Direct Attach as the type of port through the ethtool interface. Signed-off-by:
-
Shannon Nelson authored
This fixes an issue when clearing out the RAR entries. If RAR[0] is the only address in use, don't clear the others. Signed-off-by:
Shannon Nelson <shannon.nelson@intel.com> Signed-off-by:
-
Don Skidmore authored
82598 shouldn't try and access LINKS2 while configuring link and flow control. This is an 82599-only register. Signed-off-by:
Don Skidmore <donald.c.skidmore@intel.com> Signed-off-by:
-
PJ Waskiewicz authored
Flow Control autoneg should be disabled for certain adapters that don't support autonegotiation of Flow Control at 10 gigabit. These interfaces are the 10GBASE-T devices, CX4, and SFP+, all running at 10 gigabit only. 1 gigabit is fine. Signed-off-by:
-
Shannon Nelson authored
The driver was doing a divide by zero when adjusting tx-usecs. This patch removes the divide by zero code and changes the logic slightly to ignore tx-usecs in the case of shared TxRx vectors. Cc: Jesse Brandeburg <jesse.brandeburg@intel.com> Signed-off-by:
-
andrew hendry authored
Calls to x25_dev_get check for dev = NULL which was not set. It allowed x25 to set routes and ioctls on down interfaces. This caused oopses and refcnt problems on device_unregister. Signed-off-by:
Andrew Hendry <andrew.hendry@gmail.com> Signed-off-by:
-
andrew hendry authored
Adds error checking to x25_init. Signed-off-by:
-
andrew hendry authored
Moves the CONFIG_SYSCTL ifdefs in x25_init into header. Signed-off-by:
"Eric W. Biederman" <ebiederm@xmission.com> Signed-off-by:
-
Kevin Hilman authored
Convert smc91x driver from legacy PM hooks over to using dev_pm_ops. Tested on OMAP3 platform. Signed-off-by:
Kevin Hilman <khilman@deeprootsystems.com> Acked-by:
Nicolas Pitre <nico@fluxnic.net> Signed-off-by:
-
-
Ben Hutchings authored
Add 'likely' hint to test of rx_checksum_enabled. Don't count IP fragments; the IP stack can do that. Do count non-matching multicast packets. Signed-off-by:
Ben Hutchings <bhutchings@solarflare.com> Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Matthew Slattery authored
The "bug9141 workaround" of setting TX_FLUSH_MIN_LEN_EN should really be considered as a normal bit of configuration rather than a workaround. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Steve Hodgson authored
The strap bits are only important on Falcon A and all production boards using it have fixed-speed 10G PHYs. Replace dummy MAC operations with default MAC operations. Signed-off-by:
-
Steve Hodgson authored
We never use MDIO in atomic context, so we don't need to spin. Signed-off-by:
-
Steve Hodgson authored
Reading standard registers on the QT2025C before its firmware has booted may cause the boot process to fail. Therefore, follow the recommended reset sequence before reading its id registers. Either order works for the QT2022C2, so don't differentiate. Signed-off-by:
-
Steve Hodgson authored
Falcon can generate events for LASI interrupts from the PHY, but in practice we have never implemented this in reference designs. Instead we have polled, inserted the appropriate events, and then handled the events later. This is a waste of time and code. Instead, make PHY poll functions update the link state synchronously and report whether it changed. We can still make use of the LASI registers as a shortcut on the SFT9001. Signed-off-by:
-
- Nov 26, 2009
-
-
Patrick McHardy authored
Currently the UP/DOWN state of VLANs is synchronized to the state of the underlying device, meaning all VLANs are set down once the underlying device is set down. This causes all routes to the VLAN devices to vanish. Add a flag to specify a "loose binding" mode, in which only the operstate is transfered, but the VLAN device state is independant. Signed-off-by:
Patrick McHardy <kaber@trash.net> Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
From: Steve Hodgson <shodgson@solarflare.com> Currently we can set multicast hash immediately (in atomic context) but must delay setting MAC promiscuity. There is not that much point in deferring one but not the other, and setting the multicast hash on Siena will involve a firmware request. So process them both in efx_mac_work(). Also, set the broadcast bit in the multicast hash in efx_set_multicast_list(), since this is required for both Falcon and Siena. Signed-off-by:
-
Ben Hutchings authored
From: Steve Hodgson <shodgson@solarflare.com> Only the XMAC on Falcon needs help from the driver to poll and reset the MAC-PHY link (XAUI); GMII is a simple parallel bus and on later NICs firmware takes care of the XAUI link. Also, an XMAC interrupt currently schedules a work item which simply clears a flag (efx_nic::mac_up) to be checked by the regular monitor (or the next link reconfiguration, if that is sooner). Rename the flag to xmac_poll_required, changing its sense. Remove the needless indirection and just set the flag immediately. Call falcon_xmac_poll() directly where required. Add a new generic operation mac_op::check_fault to check the link outside of regular monitoring, as required during self-tests. (Note that this leaves us with an unused work item, but we will immediately have another use for it.) Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
From: Steve Hodgson <shodgson@solarflare.com> Currently we initiate MAC stats DMA and busy-wait for completion when stats are requested. We can improve on this with a periodic timer to initiate and poll for stats, and opportunistically poll when stats are requested. Since efx_nic::stats_disable_count and efx_stats_{disable,enable}() are Falcon-specific, rename them and move them accordingly. Signed-off-by: -
Ben Hutchings authored
Although efx_init_port() is only called at probe time and so cannot race with port reconfiguration, most of the functions it calls can expect to be called with the MAC lock held. Signed-off-by:
-
Steve Hodgson authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Avoid overrunning the hardware limit of 4 concurrent RX queue flushes. Expand the queue flush state to support this. Make similar changes to TX flushing to keep the code symmetric. Signed-off-by:
-
Ben Hutchings authored
Put all static information in struct falcon_board_type and replace it with a pointer in struct falcon_board. Simplify probing aocordingly. Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Signed-off-by:
-
Ben Hutchings authored
Although all the defined fields in these registers are within 32 bits, they are architecturally defined as 128-bit like most other Falcon registers. In particular, we must use efx_reado() to ensure proper locking when reading MD_STAT_REG. Signed-off-by:
-
Ben Hutchings authored
These were accidentally undersized by a factor of 2, which limited performance. Signed-off-by:
-
Arnd Bergmann authored
In order to support all three modes of macvlan at runtime, extend the existing netlink protocol to allow choosing the mode per macvlan slave interface. This depends on a matching patch to iproute2 in order to become accessible in user land. Signed-off-by:
Arnd Bergmann <arnd@arndb.de> Acked-by:
-
