Commit cb0c7005 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by David S. Miller

netdev: convert at1700 to net_device_ops

Remove unneeded memset (alloc_etherdev does it already).
Signed-off-by: default avatarStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 8afb1ceb
......@@ -249,6 +249,17 @@ out:
return ERR_PTR(err);
}
static const struct net_device_ops at1700_netdev_ops = {
.ndo_open = net_open,
.ndo_stop = net_close,
.ndo_start_xmit = net_send_packet,
.ndo_set_multicast_list = set_rx_mode,
.ndo_tx_timeout = net_tx_timeout,
.ndo_change_mtu = eth_change_mtu,
.ndo_set_mac_address = eth_mac_addr,
.ndo_validate_addr = eth_validate_addr,
};
/* The Fujitsu datasheet suggests that the NIC be probed for by checking its
"signature", the default bit pattern after a reset. This *doesn't* work --
there is no way to reset the bus interface without a complete power-cycle!
......@@ -448,13 +459,7 @@ found:
if (net_debug)
printk(version);
memset(lp, 0, sizeof(struct net_local));
dev->open = net_open;
dev->stop = net_close;
dev->hard_start_xmit = net_send_packet;
dev->set_multicast_list = &set_rx_mode;
dev->tx_timeout = net_tx_timeout;
dev->netdev_ops = &at1700_netdev_ops;
dev->watchdog_timeo = TX_TIMEOUT;
spin_lock_init(&lp->lock);
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment