Commit c64213cd authored by Stephen Hemminger's avatar Stephen Hemminger Committed by David S. Miller
Browse files

bnx2x: convert to net_device_ops



Convert driver to new net_device_ops. Compile tested only.
Signed-off-by: default avatarStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 6557d7b8
......@@ -10002,6 +10002,25 @@ static void poll_bnx2x(struct net_device *dev)
}
#endif
static const struct net_device_ops bnx2x_netdev_ops = {
.ndo_open = bnx2x_open,
.ndo_stop = bnx2x_close,
.ndo_start_xmit = bnx2x_start_xmit,
.ndo_set_multicast_list = bnx2x_set_rx_mode,
.ndo_set_mac_address = bnx2x_change_mac_addr,
.ndo_validate_addr = eth_validate_addr,
.ndo_do_ioctl = bnx2x_ioctl,
.ndo_change_mtu = bnx2x_change_mtu,
.ndo_tx_timeout = bnx2x_tx_timeout,
#ifdef BCM_VLAN
.ndo_vlan_rx_register = bnx2x_vlan_rx_register,
#endif
#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER)
.ndo_poll_controller = poll_bnx2x,
#endif
};
static int __devinit bnx2x_init_dev(struct pci_dev *pdev,
struct net_device *dev)
{
......@@ -10112,23 +10131,10 @@ static int __devinit bnx2x_init_dev(struct pci_dev *pdev,
REG_WR(bp, PXP2_REG_PGL_ADDR_90_F0 + BP_PORT(bp)*16, 0);
REG_WR(bp, PXP2_REG_PGL_ADDR_94_F0 + BP_PORT(bp)*16, 0);
dev->hard_start_xmit = bnx2x_start_xmit;
dev->watchdog_timeo = TX_TIMEOUT;
dev->netdev_ops = &bnx2x_netdev_ops;
dev->ethtool_ops = &bnx2x_ethtool_ops;
dev->open = bnx2x_open;
dev->stop = bnx2x_close;
dev->set_multicast_list = bnx2x_set_rx_mode;
dev->set_mac_address = bnx2x_change_mac_addr;
dev->do_ioctl = bnx2x_ioctl;
dev->change_mtu = bnx2x_change_mtu;
dev->tx_timeout = bnx2x_tx_timeout;
#ifdef BCM_VLAN
dev->vlan_rx_register = bnx2x_vlan_rx_register;
#endif
#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER)
dev->poll_controller = poll_bnx2x;
#endif
dev->features |= NETIF_F_SG;
dev->features |= NETIF_F_HW_CSUM;
if (bp->flags & USING_DAC_FLAG)
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment