Commit 1436b301 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by David S. Miller
Browse files

sky2: convert to net_device_ops



Convert to new network device ops interface. Slight additional complexity
here because the second port does not allow netpoll and therefore has
different virtual function table.
Signed-off-by: default avatarStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 651c2466
......@@ -3979,7 +3979,7 @@ static int sky2_device_event(struct notifier_block *unused,
struct net_device *dev = ptr;
struct sky2_port *sky2 = netdev_priv(dev);
if (dev->open != sky2_up || !sky2_debug)
if (dev->netdev_ops->ndo_open != sky2_up || !sky2_debug)
return NOTIFY_DONE;
switch(event) {
......@@ -4041,6 +4041,39 @@ static __exit void sky2_debug_cleanup(void)
#define sky2_debug_cleanup()
#endif
/* Two copies of network device operations to handle special case of
not allowing netpoll on second port */
static const struct net_device_ops sky2_netdev_ops[2] = {
{
.ndo_open = sky2_up,
.ndo_stop = sky2_down,
.ndo_do_ioctl = sky2_ioctl,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_mac_address = sky2_set_mac_address,
.ndo_set_multicast_list = sky2_set_multicast,
.ndo_change_mtu = sky2_change_mtu,
.ndo_tx_timeout = sky2_tx_timeout,
#ifdef SKY2_VLAN_TAG_USED
.ndo_vlan_rx_register = sky2_vlan_rx_register,
#endif
#ifdef CONFIG_NET_POLL_CONTROLLER
.ndo_poll_controller = sky2_netpoll,
#endif
},
{
.ndo_open = sky2_up,
.ndo_stop = sky2_down,
.ndo_do_ioctl = sky2_ioctl,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_mac_address = sky2_set_mac_address,
.ndo_set_multicast_list = sky2_set_multicast,
.ndo_change_mtu = sky2_change_mtu,
.ndo_tx_timeout = sky2_tx_timeout,
#ifdef SKY2_VLAN_TAG_USED
.ndo_vlan_rx_register = sky2_vlan_rx_register,
#endif
},
};
/* Initialize network device */
static __devinit struct net_device *sky2_init_netdev(struct sky2_hw *hw,
......@@ -4057,20 +4090,10 @@ static __devinit struct net_device *sky2_init_netdev(struct sky2_hw *hw,
SET_NETDEV_DEV(dev, &hw->pdev->dev);
dev->irq = hw->pdev->irq;
dev->open = sky2_up;
dev->stop = sky2_down;
dev->do_ioctl = sky2_ioctl;
dev->hard_start_xmit = sky2_xmit_frame;
dev->set_multicast_list = sky2_set_multicast;
dev->set_mac_address = sky2_set_mac_address;
dev->change_mtu = sky2_change_mtu;
SET_ETHTOOL_OPS(dev, &sky2_ethtool_ops);
dev->tx_timeout = sky2_tx_timeout;
dev->watchdog_timeo = TX_WATCHDOG;
#ifdef CONFIG_NET_POLL_CONTROLLER
if (port == 0)
dev->poll_controller = sky2_netpoll;
#endif
dev->netdev_ops = &sky2_netdev_ops[port];
sky2 = netdev_priv(dev);
sky2->netdev = dev;
......@@ -4104,7 +4127,6 @@ static __devinit struct net_device *sky2_init_netdev(struct sky2_hw *hw,
if (!(sky2->hw->chip_id == CHIP_ID_YUKON_FE_P &&
sky2->hw->chip_rev == CHIP_REV_YU_FE2_A0)) {
dev->features |= NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX;
dev->vlan_rx_register = sky2_vlan_rx_register;
}
#endif
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment