-
Mike Hibler authored
To enable WhOL, you need to add outlets table entries for nodes which are whol-enabled. The power_id encodes the interface on boss to use: +---------+-----------+--------+----------------+ | node_id | power_id | outlet | last_power | +---------+-----------+--------+----------------+ | pcwf6 | whol-fxp0 | 0 | 20050318152119 | +---------+-----------+--------+----------------+ You then need interfaces and wires table entries for that interface on boss, so that snmpit works with syntax like "boss:1". This is probably not really needed once the VLAN has been setup. You need a magic VLAN called "WhOL", I used VLAN 999. Add it to all the switches and trunks. Put boss's port in it. It will remain there, enabled, forever. In the interfaces table entry for every interface that supports WhOL, you need to set the 'whol' field to 1.
d9d8a58e