ht6560b: convert to use ide_timing_find_mode()

There should be no functional changes caused by this patch.
Acked-by: 's avatarSergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: 's avatarBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
parent cc57ccc0
......@@ -1001,6 +1001,7 @@ config BLK_DEV_DTC2278
config BLK_DEV_HT6560B
tristate "Holtek HT6560B support"
select IDE_TIMINGS
help
This driver is enabled at runtime using the "ht6560b.probe" kernel
boot parameter. It enables support for the secondary IDE interface
......
......@@ -216,6 +216,7 @@ static u8 ht_pio2timings(ide_drive_t *drive, const u8 pio)
if (pio) {
unsigned int cycle_time;
struct ide_timing *t = ide_timing_find_mode(XFER_PIO_0 + pio);
cycle_time = ide_pio_cycle_time(drive, pio);
......@@ -224,10 +225,8 @@ static u8 ht_pio2timings(ide_drive_t *drive, const u8 pio)
* actual cycle time for recovery and activity
* according system bus speed.
*/
active_time = ide_pio_timings[pio].active_time;
recovery_time = cycle_time
- active_time
- ide_pio_timings[pio].setup_time;
active_time = t->active;
recovery_time = cycle_time - active_time - t->setup;
/*
* Cycle times should be Vesa bus cycles
*/
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment