Commit 76d55564 authored by Timo Kokkonen's avatar Timo Kokkonen Committed by Ulf Hansson

mmc: host: atmel-mci: Add support for non-removable slots

Add support for non-removable slots which have no card detection GPIO
and which should not be polled for a card change.
Signed-off-by: default avatarTimo Kokkonen <timo.kokkonen@offcode.fi>
Acked-by: default avatarLudovic Desroches <ludovic.desroches@atmel.com>
Signed-off-by: default avatarUlf Hansson <ulf.hansson@linaro.org>
parent 0654bb3c
......@@ -560,6 +560,9 @@ atmci_of_init(struct platform_device *pdev)
pdata->slot[slot_id].detect_is_active_high =
of_property_read_bool(cnp, "cd-inverted");
pdata->slot[slot_id].non_removable =
of_property_read_bool(cnp, "non-removable");
pdata->slot[slot_id].wp_pin =
of_get_named_gpio(cnp, "wp-gpios", 0);
}
......@@ -2206,8 +2209,12 @@ static int __init atmci_init_slot(struct atmel_mci *host,
}
}
if (!gpio_is_valid(slot->detect_pin))
mmc->caps |= MMC_CAP_NEEDS_POLL;
if (!gpio_is_valid(slot->detect_pin)) {
if (slot_data->non_removable)
mmc->caps |= MMC_CAP_NONREMOVABLE;
else
mmc->caps |= MMC_CAP_NEEDS_POLL;
}
if (gpio_is_valid(slot->wp_pin)) {
if (devm_gpio_request(&host->pdev->dev, slot->wp_pin,
......
......@@ -11,6 +11,7 @@
* @detect_pin: GPIO pin wired to the card detect switch
* @wp_pin: GPIO pin wired to the write protect sensor
* @detect_is_active_high: The state of the detect pin when it is active
* @non_removable: The slot is not removable, only detect once
*
* If a given slot is not present on the board, @bus_width should be
* set to 0. The other fields are ignored in this case.
......@@ -26,6 +27,7 @@ struct mci_slot_pdata {
int detect_pin;
int wp_pin;
bool detect_is_active_high;
bool non_removable;
};
/**
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment