Commit e86abc68 authored by Johannes Berg's avatar Johannes Berg

cfg80211/mac80211: clarify RSSI CQM reporting requirements

The previous patch changed mac80211 to always report an event
after a CQM RSSI reconfiguration. Document that as expected
behaviour in both the cfg80211 and mac80211 API.

Currently, iwlmvm already implements that behaviour; the other
drivers implementing CQM RSSI events may have to be changed.

This behaviour lets userspace know what the current state is
without relying on querying the data which is racy.
Reviewed-by: default avatarSharon, Sara <sara.sharon@intel.com>
Signed-off-by: default avatarJohannes Berg <johannes.berg@intel.com>
parent 520c75dc
......@@ -2399,6 +2399,10 @@ struct cfg80211_qos_map {
* @set_power_mgmt: Configure WLAN power management. A timeout value of -1
* allows the driver to adjust the dynamic ps timeout value.
* @set_cqm_rssi_config: Configure connection quality monitor RSSI threshold.
* After configuration, the driver should (soon) send an event indicating
* the current level is above/below the configured threshold; this may
* need some care when the configuration is changed (without first being
* disabled.)
* @set_cqm_txe_config: Configure connection quality monitor TX error
* thresholds.
* @sched_scan_start: Tell the driver to start a scheduled scan.
......
......@@ -482,7 +482,9 @@ struct ieee80211_event {
* Note that with TDLS this can be the case (channel is HT, protection must
* be used from this field) even when the BSS association isn't using HT.
* @cqm_rssi_thold: Connection quality monitor RSSI threshold, a zero value
* implies disabled
* implies disabled. As with the cfg80211 callback, a change here should
* cause an event to be sent indicating where the current value is in
* relation to the newly configured threshold.
* @cqm_rssi_hyst: Connection quality monitor RSSI hysteresis
* @arp_addr_list: List of IPv4 addresses for hardware ARP filtering. The
* may filter ARP queries targeted for other addresses than listed here.
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment