Commit e464af24 authored by David Fries's avatar David Fries Committed by Linus Torvalds
Browse files

W1: ds2490.c reset ds2490 in init



Reset the device in init as it can be in a bad state.  This is necessary
because a block write will wait for data to be placed in the output buffer
and block any later commands which will keep accumulating and the device
will not be idle.  Another case is removing the ds2490 module while a bus
search is in progress, somehow a few commands get through, but the input
transfers fail leaving data in the input buffer.  This will cause the next
read to fail see the note in ds_recv_data.
Signed-off-by: default avatarDavid Fries <david@fries.net>
Signed-off-by: default avatarEvgeniy Polyakov <johnpol@2ka.mipt.ru>
Signed-off-by: default avatarAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
parent 7a4b9706
......@@ -316,6 +316,15 @@ static int ds_recv_data(struct ds_device *dev, unsigned char *buf, int size)
int count, err;
struct ds_status st;
/* Careful on size. If size is less than what is available in
* the input buffer, the device fails the bulk transfer and
* clears the input buffer. It could read the maximum size of
* the data buffer, but then do you return the first, last, or
* some set of the middle size bytes? As long as the rest of
* the code is correct there will be size bytes waiting. A
* call to ds_wait_status will wait until the device is idle
* and any data to be received would have been available.
*/
count = 0;
err = usb_bulk_msg(dev->udev, usb_rcvbulkpipe(dev->udev, dev->ep[EP_DATA_IN]),
buf, size, &count, 1000);
......@@ -824,6 +833,18 @@ static int ds_w1_init(struct ds_device *dev)
{
memset(&dev->master, 0, sizeof(struct w1_bus_master));
/* Reset the device as it can be in a bad state.
* This is necessary because a block write will wait for data
* to be placed in the output buffer and block any later
* commands which will keep accumulating and the device will
* not be idle. Another case is removing the ds2490 module
* while a bus search is in progress, somehow a few commands
* get through, but the input transfers fail leaving data in
* the input buffer. This will cause the next read to fail
* see the note in ds_recv_data.
*/
ds_send_control_cmd(dev, CTL_RESET_DEVICE, 0);
dev->master.data = dev;
dev->master.touch_bit = &ds9490r_touch_bit;
/* read_bit and write_bit in w1_bus_master are expected to set and
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment