Commit df6ba5d8 authored by Luciano Coelho's avatar Luciano Coelho Committed by John W. Linville
Browse files

mac80211: add hw configuration for max ampdu buffer size



Some devices don't support the maximum AMDPU buffer size of 64, so we
need to add an option to configure this in the hardware configuration.
This value will be used in the ADDBA response instead of the value
suggested in the request, if the latter is greater than the max
supported.
Signed-off-by: default avatarLuciano Coelho <coelho@ti.com>
Tested-by: default avatarJuuso Oikarinen <juuso.oikarinen@nokia.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent dcac908b
......@@ -1147,6 +1147,13 @@ enum ieee80211_hw_flags {
* @napi_weight: weight used for NAPI polling. You must specify an
* appropriate value here if a napi_poll operation is provided
* by your driver.
* @max_rx_aggregation_subframes: maximum buffer size (number of
* sub-frames) to be used for A-MPDU block ack receiver
* aggregation.
* This is only relevant if the device has restrictions on the
* number of subframes, if it relies on mac80211 to do reordering
* it shouldn't be set.
*/
struct ieee80211_hw {
struct ieee80211_conf conf;
......@@ -1165,6 +1172,7 @@ struct ieee80211_hw {
u8 max_rates;
u8 max_report_rates;
u8 max_rate_tries;
u8 max_rx_aggregation_subframes;
};
/**
......
......@@ -239,6 +239,9 @@ void ieee80211_process_addba_request(struct ieee80211_local *local,
buf_size = buf_size << sband->ht_cap.ampdu_factor;
}
/* make sure the size doesn't exceed the maximum supported by the hw */
if (buf_size > local->hw.max_rx_aggregation_subframes)
buf_size = local->hw.max_rx_aggregation_subframes;
/* examine state machine */
mutex_lock(&sta->ampdu_mlme.mtx);
......
......@@ -552,6 +552,7 @@ struct ieee80211_hw *ieee80211_alloc_hw(size_t priv_data_len,
local->hw.queues = 1;
local->hw.max_rates = 1;
local->hw.max_report_rates = 0;
local->hw.max_rx_aggregation_subframes = IEEE80211_MAX_AMPDU_BUF;
local->hw.conf.long_frame_max_tx_count = wiphy->retry_long;
local->hw.conf.short_frame_max_tx_count = wiphy->retry_short;
local->user_power_level = -1;
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment