Commit c3777c19 authored by Ohad Ben-Cohen's avatar Ohad Ben-Cohen Committed by Tony Lindgren
Browse files

omap: zoom3: wlan board muxing



Add board muxing to support the wlan wl1271 chip that is
hardwired to mmc2 (third mmc controller) on the ZOOM3.
Signed-off-by: default avatarOhad Ben-Cohen <ohadb@ti.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 7b2308cf
......@@ -46,6 +46,19 @@ static void __init omap_zoom_init_irq(void)
#ifdef CONFIG_OMAP_MUX
static struct omap_board_mux board_mux[] __initdata = {
/* WLAN IRQ - GPIO 162 */
OMAP3_MUX(MCBSP1_CLKX, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP),
/* WLAN POWER ENABLE - GPIO 101 */
OMAP3_MUX(CAM_D2, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT),
/* WLAN SDIO: MMC3 CMD */
OMAP3_MUX(MCSPI1_CS1, OMAP_MUX_MODE3 | OMAP_PIN_INPUT_PULLUP),
/* WLAN SDIO: MMC3 CLK */
OMAP3_MUX(ETK_CLK, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
/* WLAN SDIO: MMC3 DAT[0-3] */
OMAP3_MUX(ETK_D3, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
OMAP3_MUX(ETK_D4, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
OMAP3_MUX(ETK_D5, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
OMAP3_MUX(ETK_D6, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
{ .reg_offset = OMAP_MUX_TERMINATOR },
};
#else
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment