Commit c1863bed authored by Sebastian Siewior's avatar Sebastian Siewior Committed by Greg Ungerer
Browse files

m68knommu: remove RPXCLASSIC from the m68k tree



This ifdefs are leftovers from the time as the driver was running
on a ppc.
Signed-off-by: default avatarSebastian Siewior <bigeasy@linutronix.de>
Signed-off-by: default avatarGreg Ungerer <gerg@uclinux.org>
parent 0d176af5
......@@ -43,17 +43,9 @@
#include <asm/pgtable.h>
#include <asm/cacheflush.h>
#if defined(CONFIG_M523x) || defined(CONFIG_M527x) || \
defined(CONFIG_M5272) || defined(CONFIG_M528x) || \
defined(CONFIG_M520x) || defined(CONFIG_M532x)
#include <asm/coldfire.h>
#include <asm/mcfsim.h>
#include "fec.h"
#else
#include <asm/8xx_immap.h>
#include <asm/mpc8xx.h>
#include "commproc.h"
#endif
#if defined(CONFIG_FEC2)
#define FEC_MAX_PORTS 2
......@@ -1229,14 +1221,9 @@ static phy_info_t const * const phy_info[] = {
/* ------------------------------------------------------------------------- */
#ifdef HAVE_mii_link_interrupt
#ifdef CONFIG_RPXCLASSIC
static void
mii_link_interrupt(void *dev_id);
#else
static irqreturn_t
mii_link_interrupt(int irq, void * dev_id);
#endif
#endif
#if defined(CONFIG_M5272)
/*
......@@ -1789,20 +1776,6 @@ static void __inline__ fec_request_intrs(struct net_device *dev)
if (request_8xxirq(FEC_INTERRUPT, fec_enet_interrupt, 0, "fec", dev) != 0)
panic("Could not allocate FEC IRQ!");
#ifdef CONFIG_RPXCLASSIC
/* Make Port C, bit 15 an input that causes interrupts.
*/
immap->im_ioport.iop_pcpar &= ~0x0001;
immap->im_ioport.iop_pcdir &= ~0x0001;
immap->im_ioport.iop_pcso &= ~0x0001;
immap->im_ioport.iop_pcint |= 0x0001;
cpm_install_handler(CPMVEC_PIO_PC15, mii_link_interrupt, dev);
/* Make LEDS reflect Link status.
*/
*((uint *) RPX_CSR_ADDR) &= ~BCSR2_FETHLEDMODE;
#endif
}
static void __inline__ fec_get_mac(struct net_device *dev)
......@@ -1811,16 +1784,6 @@ static void __inline__ fec_get_mac(struct net_device *dev)
bd = (bd_t *)__res;
memcpy(dev->dev_addr, bd->bi_enetaddr, ETH_ALEN);
#ifdef CONFIG_RPXCLASSIC
/* The Embedded Planet boards have only one MAC address in
* the EEPROM, but can have two Ethernet ports. For the
* FEC port, we create another address by setting one of
* the address bits above something that would have (up to
* now) been allocated.
*/
dev->dev_adrd[3] |= 0x80;
#endif
}
static void __inline__ fec_set_mii(struct net_device *dev, struct fec_enet_private *fep)
......@@ -2099,13 +2062,8 @@ mii_discover_phy(uint mii_reg, struct net_device *dev)
/* This interrupt occurs when the PHY detects a link change.
*/
#ifdef HAVE_mii_link_interrupt
#ifdef CONFIG_RPXCLASSIC
static void
mii_link_interrupt(void *dev_id)
#else
static irqreturn_t
mii_link_interrupt(int irq, void * dev_id)
#endif
{
struct net_device *dev = dev_id;
struct fec_enet_private *fep = netdev_priv(dev);
......
......@@ -519,25 +519,6 @@ typedef struct scc_enet {
#define SICR_ENET_CLKRT ((uint)0x00002c00)
#endif
#ifdef CONFIG_RPXCLASSIC
/* Bits in parallel I/O port registers that have to be set/cleared
* to configure the pins for SCC1 use.
*/
#define PA_ENET_RXD ((ushort)0x0001)
#define PA_ENET_TXD ((ushort)0x0002)
#define PA_ENET_TCLK ((ushort)0x0200)
#define PA_ENET_RCLK ((ushort)0x0800)
#define PB_ENET_TENA ((uint)0x00001000)
#define PC_ENET_CLSN ((ushort)0x0010)
#define PC_ENET_RENA ((ushort)0x0020)
/* Control bits in the SICR to route TCLK (CLK2) and RCLK (CLK4) to
* SCC1. Also, make sure GR1 (bit 24) and SC1 (bit 25) are zero.
*/
#define SICR_ENET_MASK ((uint)0x000000ff)
#define SICR_ENET_CLKRT ((uint)0x0000003d)
#endif
/* SCC Event register as used by Ethernet.
*/
#define SCCE_ENET_GRA ((ushort)0x0080) /* Graceful stop complete */
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment