Commit b30ee754 authored by Hauke Mehrtens's avatar Hauke Mehrtens Committed by John W. Linville
Browse files

brcmsmac: remove ai_pci_setup()

This is now done by calling bcma_core_pci_irq_ctl()
Signed-off-by: default avatarHauke Mehrtens <>
Tested-by: default avatarArend van Spriel <>
Signed-off-by: default avatarJohn W. Linville <>
parent 63286295
......@@ -842,29 +842,6 @@ void ai_pci_down(struct si_pub *sih)
pcicore_down(sii->pch, SI_PCIDOWN);
* Configure the pci core for pci client (NIC) action
* coremask is the bitvec of cores by index to be enabled.
void ai_pci_setup(struct si_pub *sih, uint coremask)
struct si_info *sii;
u32 w;
sii = (struct si_info *)sih;
* Enable sb->pci interrupts. Assume
* PCI rev 2.3 support was added in pci core rev 6 and things changed..
if (PCIE(sih)) {
/* pci config write to set this core bit in PCIIntMask */
pci_read_config_dword(sii->pcibus, PCI_INT_MASK, &w);
w |= (coremask << PCI_SBIM_SHIFT);
pci_write_config_dword(sii->pcibus, PCI_INT_MASK, w);
* Fixup SROMless PCI device's configuration.
* The current core may be changed upon return.
......@@ -196,7 +196,6 @@ extern u32 ai_core_cflags(struct bcma_device *core, u32 mask, u32 val);
extern struct si_pub *ai_attach(struct bcma_bus *pbus);
extern void ai_detach(struct si_pub *sih);
extern uint ai_cc_reg(struct si_pub *sih, uint regoff, u32 mask, u32 val);
extern void ai_pci_setup(struct si_pub *sih, uint coremask);
extern void ai_clkctl_init(struct si_pub *sih);
extern u16 ai_clkctl_fast_pwrup_delay(struct si_pub *sih);
extern bool ai_clkctl_cc(struct si_pub *sih, uint mode);
......@@ -5050,8 +5050,6 @@ static void brcms_b_hw_up(struct brcms_hardware *wlc_hw)
static int brcms_b_up_prep(struct brcms_hardware *wlc_hw)
uint coremask;
BCMMSG(wlc_hw->wlc->wiphy, "wl%d\n", wlc_hw->unit);
......@@ -5066,9 +5064,8 @@ static int brcms_b_up_prep(struct brcms_hardware *wlc_hw)
* Configure pci/pcmcia here instead of in brcms_c_attach()
* to allow mfg hotswap: down, hotswap (chip power cycle), up.
coremask = (1 << wlc_hw->wlc->core->coreidx);
ai_pci_setup(wlc_hw->sih, coremask);
bcma_core_pci_irq_ctl(&wlc_hw->d11core->bus->drv_pci, wlc_hw->d11core,
* Need to read the hwradio status here to cover the case where the
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment