Commit b2887410 authored by Vasanthakumar Thiagarajan's avatar Vasanthakumar Thiagarajan Committed by Kalle Valo
Browse files

ath10k: fill in wmi 10.4 command handlers for addba/delba debug commands



WMI 10.4 uses the same command interface as QCA988X for addba/delba
debug wmi commands. Fill wmi_10_4_ops table with the functions used
for QCA988X for these commands.

With this change, the following debugfs entries can be used to
configure the aggregation mode and to send addba request,
addba response and delba respectively in manual aggregation mode
for QCA99X0 chip.

/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/aggr_mode
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba_resp
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/delba
Signed-off-by: default avatarVasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com>
Signed-off-by: default avatarKalle Valo <kvalo@qca.qualcomm.com>
parent 2b0a2e0d
......@@ -6597,6 +6597,10 @@ static const struct wmi_ops wmi_10_4_ops = {
.gen_pktlog_enable = ath10k_wmi_op_gen_pktlog_enable,
.gen_pktlog_disable = ath10k_wmi_op_gen_pktlog_disable,
.gen_pdev_set_quiet_mode = ath10k_wmi_op_gen_pdev_set_quiet_mode,
.gen_addba_clear_resp = ath10k_wmi_op_gen_addba_clear_resp,
.gen_addba_send = ath10k_wmi_op_gen_addba_send,
.gen_addba_set_resp = ath10k_wmi_op_gen_addba_set_resp,
.gen_delba_send = ath10k_wmi_op_gen_delba_send,
/* shared with 10.2 */
.gen_peer_assoc = ath10k_wmi_10_2_op_gen_peer_assoc,
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment