Commit 41e2b05b authored by Rajkumar Manoharan's avatar Rajkumar Manoharan Committed by John W. Linville
Browse files

ath9k: set 40 Mhz rate only if hw is configured in ht40



Whenever there is a channel width change from 40 Mhz to 20 Mhz,
the hardware is reconfigured to ht20. Meantime before doing
the rate control updation, the packets are being transmitted are
selected rate with IEEE80211_TX_RC_40_MHZ_WIDTH.

While transmitting ht40 rate packets in ht20 mode is causing
baseband panic with AR9003 based chips.

==== BB update: BB status=0x02001109 ====
ath: ** BB state: wd=1 det=1 rdar=0 rOFDM=1 rCCK=1 tOFDM=0 tCCK=0 agc=2
src=0 **
ath: ** BB WD cntl: cntl1=0xffff0085 cntl2=0x00000004 **
ath: ** BB mode: BB_gen_controls=0x000033c0 **
ath: ** BB busy times: rx_clear=99%, rx_frame=0%, tx_frame=0% **
ath: ==== BB update: done ====

Cc: stable@kernel.org
Signed-off-by: default avatarRajkumar Manoharan <rmanoharan@atheros.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent 51ac8cbb
......@@ -689,7 +689,8 @@ static void ath_rc_rate_set_series(const struct ath_rate_table *rate_table,
if (WLAN_RC_PHY_HT(rate_table->info[rix].phy)) {
rate->flags |= IEEE80211_TX_RC_MCS;
if (WLAN_RC_PHY_40(rate_table->info[rix].phy))
if (WLAN_RC_PHY_40(rate_table->info[rix].phy) &&
conf_is_ht40(&txrc->hw->conf))
rate->flags |= IEEE80211_TX_RC_40_MHZ_WIDTH;
if (WLAN_RC_PHY_SGI(rate_table->info[rix].phy))
rate->flags |= IEEE80211_TX_RC_SHORT_GI;
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment