Commit 3a9dddea authored by Felix Fietkau's avatar Felix Fietkau Committed by John W. Linville
Browse files

ath5k: disable 5 GHz support for the dualband PHY chip on dual-radio AR5312



There are two variants of AR5312 dual-band devices, one single-radio
and the other one dual-radio. On the dual-radio board, the first MAC
only supports 5 GHz, even though it has a dual-band PHY. The 2.4 GHz
part of this phy is used in pass-through mode, connecting the second
MAC with the second PHY.
Disable 2.4 GHz for the first MAC on an AR5312, but only if the board
configuration indicates a dual-radio device.
Signed-off-by: default avatarFelix Fietkau <nbd@openwrt.org>
Tested-by: default avatarSedat Dilek <sedat.dilek@gmail.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent 32377b6c
......@@ -160,6 +160,16 @@ static int ath_ahb_probe(struct platform_device *pdev)
else
reg |= AR5K_AR5312_ENABLE_WLAN1;
__raw_writel(reg, (void __iomem *) AR5K_AR5312_ENABLE);
/*
* On a dual-band AR5312, the multiband radio is only
* used as pass-through. Disable 2 GHz support in the
* driver for it
*/
if (to_platform_device(sc->dev)->id == 0 &&
(bcfg->config->flags & (BD_WLAN0|BD_WLAN1)) ==
(BD_WLAN1|BD_WLAN0))
__set_bit(ATH_STAT_2G_DISABLED, sc->status);
}
ret = ath5k_init_softc(sc, &ath_ahb_bus_ops);
......
......@@ -313,6 +313,11 @@ int ath5k_hw_init(struct ath5k_softc *sc)
goto err;
}
if (test_bit(ATH_STAT_2G_DISABLED, sc->status)) {
__clear_bit(AR5K_MODE_11B, ah->ah_capabilities.cap_mode);
__clear_bit(AR5K_MODE_11G, ah->ah_capabilities.cap_mode);
}
/* Crypto settings */
common->keymax = (sc->ah->ah_version == AR5K_AR5210 ?
AR5K_KEYTABLE_SIZE_5210 : AR5K_KEYTABLE_SIZE_5211);
......
......@@ -193,12 +193,13 @@ struct ath5k_softc {
dma_addr_t desc_daddr; /* DMA (physical) address */
size_t desc_len; /* size of TX/RX descriptors */
DECLARE_BITMAP(status, 5);
DECLARE_BITMAP(status, 6);
#define ATH_STAT_INVALID 0 /* disable hardware accesses */
#define ATH_STAT_MRRETRY 1 /* multi-rate retry support */
#define ATH_STAT_PROMISC 2
#define ATH_STAT_LEDSOFT 3 /* enable LED gpio status */
#define ATH_STAT_STARTED 4 /* opened & irqs enabled */
#define ATH_STAT_2G_DISABLED 5 /* multiband radio without 2G */
unsigned int filter_flags; /* HW flags, AR5K_RX_FILTER_* */
struct ieee80211_channel *curchan; /* current h/w channel */
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment