Commit 2808b0a9 authored by Sergei Shtylyov's avatar Sergei Shtylyov Committed by Bartlomiej Zolnierkiewicz

hpt366: UltraDMA filter for SATA cards (take 2)

The Marvell bridge chips used on HighPoint SATA cards do not seem to support
the UltraDMA modes 1, 2, and 3 as well as any MWDMA modes, so the driver needs
to account for this in the udma_filter() method.  In order to achieve that, do
the following changes:

- install the method for all chips, not only HPT36x/370 and improve the code
  formatting by killing the extra tabs while at it;

- add to the end of the 'switch' statement in the method cases for HPT372[AN]
  and HPT374 chips upon which the known SATA cards are based;

- use hwif->ultra_mask as a default mask for the ide_dma_filter() method to
  behave correctly;

- move the HPT370[A] cases below the HPT36x case for consistency.

While at it, replace the explicit UltraDMA mode masks with ATA_UDMA* constants
all over the driver...
Signed-off-by: default avatarSergei Shtylyov <sshtylyov@ru.mvista.com>
Cc: Bob Ham <rah@bash.sh>
Signed-off-by: default avatarBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
parent 6c3c22f3
/*
* linux/drivers/ide/pci/hpt366.c Version 1.11 Aug 11, 2007
* linux/drivers/ide/pci/hpt366.c Version 1.12 Aug 19, 2007
*
* Copyright (C) 1999-2003 Andre Hedrick <andre@linux-ide.org>
* Portions Copyright (C) 2001 Sun Microsystems, Inc.
......@@ -114,6 +114,7 @@
* unify HPT36x/37x timing setup code and the speedproc handlers by joining
* the register setting lists into the table indexed by the clock selected
* - set the correct hwif->ultra_mask for each individual chip
* - add UltraDMA mode filtering for the HPT37[24] based SATA cards
* Sergei Shtylyov, <sshtylyov@ru.mvista.com> or <source@mvista.com>
*/
......@@ -518,42 +519,44 @@ static int check_in_drive_list(ide_drive_t *drive, const char **list)
}
/*
* Note for the future; the SATA hpt37x we must set
* either PIO or UDMA modes 0,4,5
* The Marvell bridge chips used on the HighPoint SATA cards do not seem
* to support the UltraDMA modes 1, 2, and 3 as well as any MWDMA modes...
*/
static u8 hpt3xx_udma_filter(ide_drive_t *drive)
{
struct hpt_info *info = pci_get_drvdata(HWIF(drive)->pci_dev);
u8 mask;
ide_hwif_t *hwif = HWIF(drive);
struct hpt_info *info = pci_get_drvdata(hwif->pci_dev);
u8 mask = hwif->ultra_mask;
switch (info->chip_type) {
case HPT370A:
if (!HPT370_ALLOW_ATA100_5 ||
check_in_drive_list(drive, bad_ata100_5))
return 0x1f;
else
return 0x3f;
case HPT370:
if (!HPT370_ALLOW_ATA100_5 ||
check_in_drive_list(drive, bad_ata100_5))
mask = 0x1f;
else
mask = 0x3f;
break;
case HPT36x:
if (!HPT366_ALLOW_ATA66_4 ||
check_in_drive_list(drive, bad_ata66_4))
mask = 0x0f;
else
mask = 0x1f;
mask = ATA_UDMA3;
if (!HPT366_ALLOW_ATA66_3 ||
check_in_drive_list(drive, bad_ata66_3))
mask = 0x07;
mask = ATA_UDMA2;
break;
case HPT370:
if (!HPT370_ALLOW_ATA100_5 ||
check_in_drive_list(drive, bad_ata100_5))
mask = ATA_UDMA4;
break;
case HPT370A:
if (!HPT370_ALLOW_ATA100_5 ||
check_in_drive_list(drive, bad_ata100_5))
return ATA_UDMA4;
case HPT372 :
case HPT372A:
case HPT372N:
case HPT374 :
if (ide_dev_is_sata(drive->id))
mask &= ~0x0e;
/* Fall thru */
default:
return 0x7f;
return mask;
}
return check_in_drive_list(drive, bad_ata33) ? 0x00 : mask;
......@@ -1236,25 +1239,24 @@ static unsigned int __devinit init_chipset_hpt366(struct pci_dev *dev, const cha
static void __devinit init_hwif_hpt366(ide_hwif_t *hwif)
{
struct pci_dev *dev = hwif->pci_dev;
struct hpt_info *info = pci_get_drvdata(dev);
int serialize = HPT_SERIALIZE_IO;
u8 scr1 = 0, ata66 = hwif->channel ? 0x01 : 0x02;
u8 chip_type = info->chip_type;
u8 new_mcr, old_mcr = 0;
struct pci_dev *dev = hwif->pci_dev;
struct hpt_info *info = pci_get_drvdata(dev);
int serialize = HPT_SERIALIZE_IO;
u8 scr1 = 0, ata66 = hwif->channel ? 0x01 : 0x02;
u8 chip_type = info->chip_type;
u8 new_mcr, old_mcr = 0;
/* Cache the channel's MISC. control registers' offset */
hwif->select_data = hwif->channel ? 0x54 : 0x50;
hwif->select_data = hwif->channel ? 0x54 : 0x50;
hwif->tuneproc = &hpt3xx_tune_drive;
hwif->speedproc = &hpt3xx_tune_chipset;
hwif->quirkproc = &hpt3xx_quirkproc;
hwif->intrproc = &hpt3xx_intrproc;
hwif->maskproc = &hpt3xx_maskproc;
hwif->busproc = &hpt3xx_busproc;
hwif->tuneproc = &hpt3xx_tune_drive;
hwif->speedproc = &hpt3xx_tune_chipset;
hwif->quirkproc = &hpt3xx_quirkproc;
hwif->intrproc = &hpt3xx_intrproc;
hwif->maskproc = &hpt3xx_maskproc;
hwif->busproc = &hpt3xx_busproc;
if (chip_type <= HPT370A)
hwif->udma_filter = &hpt3xx_udma_filter;
hwif->udma_filter = &hpt3xx_udma_filter;
/*
* HPT3xxN chips have some complications:
......@@ -1504,19 +1506,19 @@ static int __devinit init_setup_hpt366(struct pci_dev *dev, ide_pci_device_t *d)
d->host_flags |= IDE_HFLAG_SINGLE;
d->enablebits[0].mask = d->enablebits[0].val = 0x10;
d->udma_mask = HPT366_ALLOW_ATA66_3 ?
(HPT366_ALLOW_ATA66_4 ? 0x1f : 0x0f) : 0x07;
d->udma_mask = HPT366_ALLOW_ATA66_3 ? (HPT366_ALLOW_ATA66_4 ?
ATA_UDMA4 : ATA_UDMA3) : ATA_UDMA2;
break;
case 3:
case 4:
d->udma_mask = HPT370_ALLOW_ATA100_5 ? 0x3f : 0x1f;
d->udma_mask = HPT370_ALLOW_ATA100_5 ? ATA_UDMA5 : ATA_UDMA4;
break;
default:
rev = 6;
/* fall thru */
case 5:
case 6:
d->udma_mask = HPT372_ALLOW_ATA133_6 ? 0x7f : 0x3f;
d->udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5;
break;
}
......@@ -1577,7 +1579,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
.init_dma = init_dma_hpt366,
.autodma = AUTODMA,
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
.udma_mask = HPT372_ALLOW_ATA133_6 ? 0x7f : 0x3f,
.udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
.bootable = OFF_BOARD,
.extra = 240,
.pio_mask = ATA_PIO4,
......@@ -1589,7 +1591,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
.init_dma = init_dma_hpt366,
.autodma = AUTODMA,
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
.udma_mask = HPT302_ALLOW_ATA133_6 ? 0x7f : 0x3f,
.udma_mask = HPT302_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
.bootable = OFF_BOARD,
.extra = 240,
.pio_mask = ATA_PIO4,
......@@ -1601,7 +1603,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
.init_dma = init_dma_hpt366,
.autodma = AUTODMA,
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
.udma_mask = HPT371_ALLOW_ATA133_6 ? 0x7f : 0x3f,
.udma_mask = HPT371_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
.bootable = OFF_BOARD,
.extra = 240,
.pio_mask = ATA_PIO4,
......@@ -1613,7 +1615,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
.init_dma = init_dma_hpt366,
.autodma = AUTODMA,
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
.udma_mask = 0x3f,
.udma_mask = ATA_UDMA5,
.bootable = OFF_BOARD,
.extra = 240,
.pio_mask = ATA_PIO4,
......@@ -1625,7 +1627,7 @@ static ide_pci_device_t hpt366_chipsets[] __devinitdata = {
.init_dma = init_dma_hpt366,
.autodma = AUTODMA,
.enablebits = {{0x50,0x04,0x04}, {0x54,0x04,0x04}},
.udma_mask = HPT372_ALLOW_ATA133_6 ? 0x7f : 0x3f,
.udma_mask = HPT372_ALLOW_ATA133_6 ? ATA_UDMA6 : ATA_UDMA5,
.bootable = OFF_BOARD,
.extra = 240,
.pio_mask = ATA_PIO4,
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment