Commit 0421eae6 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by David S. Miller
Browse files

bnx2: convert to net_device_ops



Convert driver to new net_device_ops. Compile tested only.
Signed-off-by: default avatarStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 3addc568
......@@ -7707,6 +7707,25 @@ bnx2_init_napi(struct bnx2 *bp)
}
}
static const struct net_device_ops bnx2_netdev_ops = {
.ndo_open = bnx2_open,
.ndo_start_xmit = bnx2_start_xmit,
.ndo_stop = bnx2_close,
.ndo_get_stats = bnx2_get_stats,
.ndo_set_rx_mode = bnx2_set_rx_mode,
.ndo_do_ioctl = bnx2_ioctl,
.ndo_validate_addr = eth_validate_addr,
.ndo_set_mac_address = bnx2_change_mac_addr,
.ndo_change_mtu = bnx2_change_mtu,
.ndo_tx_timeout = bnx2_tx_timeout,
#ifdef BCM_VLAN
.ndo_vlan_rx_register = bnx2_vlan_rx_register,
#endif
#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER)
.ndo_poll_controller = poll_bnx2,
#endif
};
static int __devinit
bnx2_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
{
......@@ -7731,28 +7750,13 @@ bnx2_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
return rc;
}
dev->open = bnx2_open;
dev->hard_start_xmit = bnx2_start_xmit;
dev->stop = bnx2_close;
dev->get_stats = bnx2_get_stats;
dev->set_rx_mode = bnx2_set_rx_mode;
dev->do_ioctl = bnx2_ioctl;
dev->set_mac_address = bnx2_change_mac_addr;
dev->change_mtu = bnx2_change_mtu;
dev->tx_timeout = bnx2_tx_timeout;
dev->netdev_ops = &bnx2_netdev_ops;
dev->watchdog_timeo = TX_TIMEOUT;
#ifdef BCM_VLAN
dev->vlan_rx_register = bnx2_vlan_rx_register;
#endif
dev->ethtool_ops = &bnx2_ethtool_ops;
bp = netdev_priv(dev);
bnx2_init_napi(bp);
#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER)
dev->poll_controller = poll_bnx2;
#endif
pci_set_drvdata(pdev, dev);
memcpy(dev->dev_addr, bp->mac_addr, 6);
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment