atmel-mci.h 1.31 KB
Newer Older
1 2
#ifndef __LINUX_ATMEL_MCI_H
#define __LINUX_ATMEL_MCI_H
3

4 5
#include <linux/types.h>

6
#define ATMCI_MAX_NR_SLOTS	2
7

8 9 10 11 12
/**
 * struct mci_slot_pdata - board-specific per-slot configuration
 * @bus_width: Number of data lines wired up the slot
 * @detect_pin: GPIO pin wired to the card detect switch
 * @wp_pin: GPIO pin wired to the write protect sensor
13
 * @detect_is_active_high: The state of the detect pin when it is active
14
 * @non_removable: The slot is not removable, only detect once
15 16 17 18 19
 *
 * If a given slot is not present on the board, @bus_width should be
 * set to 0. The other fields are ignored in this case.
 *
 * Any pins that aren't available should be set to a negative value.
20 21 22 23
 *
 * Note that support for multiple slots is experimental -- some cards
 * might get upset if we don't get the clock management exactly right.
 * But in most cases, it should work just fine.
24 25 26
 */
struct mci_slot_pdata {
	unsigned int		bus_width;
27 28
	int			detect_pin;
	int			wp_pin;
29
	bool			detect_is_active_high;
30
	bool			non_removable;
31 32
};

33 34
/**
 * struct mci_platform_data - board-specific MMC/SDcard configuration
35
 * @dma_slave: DMA slave interface to use in data transfers.
36 37 38
 * @slot: Per-slot configuration data.
 */
struct mci_platform_data {
39
	struct mci_dma_data	*dma_slave;
40
	struct mci_slot_pdata	slot[ATMCI_MAX_NR_SLOTS];
41 42
};

43
#endif /* __LINUX_ATMEL_MCI_H */