Commit c5f66b68 authored by Kobus Van der Merwe's avatar Kobus Van der Merwe

more wording changes...

parent 8e1837b6
......@@ -95,53 +95,9 @@ script:
sudo /local/repository/bin/nrue_scope.start.sh
After booting is complete, log onto either the enb1 and rue1
nodes. From there, you will be able to start OAI enb and ue services by running:
on 'enb1'
sudo ip link set mtu 9216 dev ifname # change ifname with the usrp interface
cd /opt/oai/develop-nr/cmake_targets/ran_build/build/
sudo ./nr-softmodem -O /local/repository/etc/gnb.conf
on 'rue1'
sudo ip link set mtu 9216 dev ifname # change ifname with the usrp interface
cd /opt/oai/develop-nr/cmake_targets/ran_build/build/
sudo ./nr-uesoftmodem --numerology 1 -r 106 --phy-test -C 3510000000 --usrp-args "addr=192.168.30.2"
To enable ue software scope, just add "-d" of following line in file /local/repository/bin/nrue.start.sh:
screen -c $OAIETCDIR/enb.screenrc -L -S ue -h 10000 /bin/bash -c "sudo $UEEXEPATH --numerology 1 -r 106 --phy-test -C 3510000000 --usrp-args "addr=192.168.30.2" -E -d"
This will stop currently running OAI enb/ue service, start enb/ue service
again in a new screen session, and then show OAI processes on 'enb1'/'rue1'.
You can detach the sesseion by ctrl-a d.
After detach, you can pull up and monitor the OAI
processes on the rue1 and enb1 nodes. Execute sudo screen -ls to
see what sessions are available. The commands for controlling services
on these nodes are located in /local/repository/bin.
OAI is a project that is in development. As such, it is not always
stable and there will be times when it gets into a failed state that
it can never recover from. Almost always, you will be able to bring
things back by either rebooting the experiment from the portal or
restarting the services by hand from the command line.
For more detailed information:
* [Getting Started](https://gitlab.flux.utah.edu/jczhu/OAI-NR/blob/master/README.md)
* [Here...](https://gitlab.flux.utah.edu/jczhu/OAI-NR/blob/master/README.md)
"""
......
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment