Commit e7797be2 authored by Robert Ricci's avatar Robert Ricci

Add expected snmpit output. Suggested by Einar Vollset @ Cornell.

parent 3d8072e1
......@@ -282,11 +282,23 @@ table, listing the node_id of each switch and the stack_id of the stack it
belongs to. You can leave the 'is_primary' column of these rows with its default
value (1).
After getting this set up, run 'snmpit -l', and make sure it doesn't give you
any error messages. If it tells you that your type of device isn't supported,
ask Utah - we have a list of supported devices in snmpit, but they are just
the ones we've tested. Hopefully, yours will work too, we just haven't tried
it.
After getting this set up, run 'wap snmpit -l', and make sure it doesn't give
you any error messages. If it tells you that your type of device isn't
supported, ask Utah - we have a list of supported devices in snmpit, but they
are just the ones we've tested. Hopefully, yours will work too, we just haven't
tried it.
Your snmpit output should look something like this:
%wap snmpit -l
VLAN Project/Experiment VName Members
--------------------------------------------------------------------------------
Control- myswitch:1
Note that 'Control-' is a truncated version of the name 'Control-hardware' that
you created in setup-network.txt . If you see any other VLANs on this list,
that's not a problem, but if you want to delete any of them, you can do that
with 'wap snmpit -o <name>'.
##### Step 4 - Setup control hardware
##### Local Only
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment