1. 01 Jul, 2005 1 commit
    • Mike Hibler's avatar
      Add "status" command that can be applied to power controllers · c946abb8
      Mike Hibler authored
      (eg. "power status rpc14-1" or "power status all").
      In rpc module, add a "status" function that is called to collect,
      well..status.  This is used by the generic power code, but more importantly,
      by the new "powermon" script (which could have just called "power status",
      but no point in parsing output twice).
  2. 04 Apr, 2005 1 commit
  3. 15 Mar, 2005 1 commit
  4. 07 Jul, 2002 1 commit
  5. 21 May, 2002 1 commit
    • Robert Ricci's avatar
      Fix for a problem that Mike discovered. The RPC input buffer is · 5a3d2cee
      Robert Ricci authored
      limited to 31 characters, so we can't give commands with more than 8
      outlets. So, we split up the outlets into groups of 8, and issue
      multiple commands, if we are passed too many outlets.
      Took some minor re-structuring, since we now may need to sync up with
      the RPC prompt more than once.
  6. 26 Nov, 2001 1 commit
    • Robert Ricci's avatar
      In order to improve experiment startup times, power now sorts nodes by · ebaac553
      Robert Ricci authored
      power controller, and controls all nodes on the same controller at
      once. This is particularly helpful when rebooting nodes connected to
      the RPCs, as you now longer have to wait through the RPCs 'rebooting'
      junk for each node.
      power_rpc27.pm and snmpit_apc.pm received some minor changes to
      support passing multiple outlets to one function call.
  7. 13 Sep, 2001 1 commit
  8. 29 Aug, 2001 1 commit
    • Leigh B. Stoller's avatar
      Fixup capture/tip/power_rpc27 so that capture returns a positive · ed55f418
      Leigh B. Stoller authored
      ack/nak for a connection so that the connecting process knows what the
      hell is going on. Turned out to be necessary for power control since
      we do that in parallel, and because it stays busy for 10 seconds on
      each power control. I think we will end up revisiting this at some
      point, adding blocking connections instead of connect/fail status.
  9. 27 Aug, 2001 2 commits
    • Leigh B. Stoller's avatar
      Ug, forgot to turn off debug mode! · 966d8fa1
      Leigh B. Stoller authored
    • Leigh B. Stoller's avatar
      Changes to sync protocol. The RPC27 spits out a bunch of silly status · e335015b
      Leigh B. Stoller authored
      goo whenever it goes inactive for more than a couple of minutes. Also,
      require that we sync up so that we know for sure that the power
      control failed. Previously, I was blindly spitting out the command
      without being sure we had a command prompt.
      Note, that we still have a problem with an active tip session messing
      up power control since only one connection can be active at a time.
      At present, there is no positive way to know that the connection was
      refused since capture accepts the connection and then closes it if
      there is an active tip session. I need to change the little handshake
      so that there is a response Yes/Know response to the secret key
  10. 14 Aug, 2001 2 commits
  11. 09 Aug, 2001 1 commit