there are things like images and osids owned by people in that group.
But exclude elabman/elabckup since they are created in the inner elab.

was turning out to be counterproductive on the ops db.

verbose option for debugging.

since it was written.

(i.e., when plab nodes are up and down a lot for short periods of time).
See the comments to figure out how it works.  It's not quite done yet, but
is good enough for now.

this check fails in that case.

should work for kernels circa 2.6.20.

the controller.  This works where the old one doesn't on an APC 7960.

Waiting to hear back from DETER about their power controllers however,
so this may change again...

image.

working on this a few weeks ago when I got sidetracked by the pubsub
project.

side of the magent

3.x to 4.x continues).

connected.

table. Note that workbench permission implies archive permission too.
Added the toggle to the project page.

Added a "stud" toggle to the user page while I was there.

root=/dev/XXX param in /boot/grub/grub.conf, since grub.conf gets read at
boot by the bootloader.

Previously it was not being filled in and would wind up '0'.  Since it was
part of the primary key along with the service, this basically meant that
only one experiment at a time could successfully use the sync-server; i.e.,
only one could have (0, 'emulab-syncd') as their primary key.